@article{20191, abstract = {High-entropy alloys (HEAs) show great potential for catalyzing complex multi-step reactions, but optimizing their parameters, i.e., composition, but also their crystallinity and morphology, remains a significant challenge. In this study, FeCoNiMoW HEAs are synthesized into either amorphous nanosheets (HEANS) or crystalline nanoparticles (HEANP), which are then used to catalyze the lithium–sulfur (Li–S) reaction of Li–S batteries (LSBs). Evaluations in symmetric cells, coin cells, and pouch cells reveal that HEANS significantly enhance LSB performance, achieving initial discharge capacities up to 1632 mAh g−1. The batteries also exhibit excellent cycling stability over 1000 cycles at 3Cand maintain high-rate performance up to 10C with a capacity of 614 mAh g−1. Comprehensive in situ analyses and density functional theory calculations demonstrate that amorphous HEANS provide more active sites, better ionic conductivity and stronger chemical interactions with lithium polysulfides (LiPS). These properties effectively suppress the shuttle effect, promote the complete S8 → Li2S conversion by reducing the impedance of the solid-electrolyte interphase, and accelerate the Li2S4 → Li2S2 step by lowering the nucleation energy barrier. Overall, this study highlights the superior catalytic properties of amorphous 2D HEAs in LSBs and offers new insights into the mechanisms of LiPS conversion.}, author = {He, Ren and Lee, Seungho and Ding, Yang and Huang, Chen and Lu, Xuan and Zheng, Lirong and Yu, Ao and Zhang, Chaoyue and Li, Canhuang and Bi, Xiaoyu and Li, Yaqiang and Liao, Yaqi and Li, Junshan and Ostovari Moghaddam, Ahmad and Yernar, Salimov and Xu, Ying and Ibáñez, Maria and Zhang, Chaoqi and Yang, Linlin and Zhou, Yingtang and Cabot, Andreu}, issn = {1616-3028}, journal = {Advanced Functional Materials}, keywords = {amorphous, high entropy alloy, in situ electrochemical impedance spec-troscopy, in situ Raman, Li–S batteries}, number = {5}, publisher = {Wiley}, title = {{Amorphous high entropy alloy nanosheets enabling robust Li–S batteries}}, doi = {10.1002/adfm.202513859}, volume = {36}, year = {2026}, } @article{18882, abstract = {Ternary liquid-like thermoelectric materials have garnered significant attention due to their ultra-low lattice thermal conductivity. Among these, Ag8SnSe6 stands out for its exceptionally low sound velocity and thermal conductivity. However, the inherent poor electrical conductivity and suboptimal thermoelectric properties of Ag8SnSe6 necessitate further improvement. Here, a novel approach is initiated to enhance the thermoelectric properties of Ag8SnSe6 by combining low-dimensionalization with intrinsic doping. For the first time, this work successfully synthesizes single-phase Ag8SnSe6 nanocrystals, ≈10 nm in size, with the correct phase and composition using a robust and reliable colloidal method. This approach represents a significant improvement over previous reports on this material. Reducing the crystal domains of Ag8SnSe6 to the nanoscale induces quantum confinement effects, increasing the density of states near the Fermi surface. It also introduces additional grain boundaries, which lower the lattice thermal conductivity and simplify structural design. Moreover, incorporating small amounts of Sn nanopowder into the Ag8SnSe6 nanocrystals before consolidation further enhances the thermoelectric performance. Sn acts as a donor dopant, increasing the electronic concentration while at the same time improving their mobility by reducing interface barriers, thus significantly improving the material transport properties. Additionally, the presence of Sn leads to the formation of point defects, dislocations, and secondary phases, which increase phonon scattering and further reduce the thermal conductivity. Through this synergistic optimization, the figure of merit shows a significant increase across a wide temperature range. Overall, a strategy is presented for the controlled preparation of Ag8SnSe6 nanocrystals, the decoupling of their electrical and thermal transport, and the practical application of this material to thermoelectric single-leg modules.}, author = {Zhao, Xueke and Li, Mengyao and Jia, Mochen and Fiedler, Christine and Nan, Bingfei and Yang, Dongwen and Li, Lei and Yuan, Zicheng and Song, Hongzhang and Liu, Yu and Ibáñez, Maria and Wang, Ziyu and Shan, Chongxin and Cabot, Andreu}, issn = {1616-3028}, journal = {Advanced Functional Materials}, number = {24}, publisher = {Wiley}, title = {{Low-dimensional structure modulation in Ag8SnSe6 for enhanced thermoelectric performance}}, doi = {10.1002/adfm.202421449}, volume = {35}, year = {2025}, } @article{13423, abstract = {Supraspheres (SS) composed of hundreds to thousands of metal nanoparticles (NPs) and crosslinked by dithiol linkers are assembled into larger structures, which are subsequently converted into nanoporous metals (NMs). Conversion is achieved by heating which removes organic molecules stabilizing the NPs and allows for NP fusion. Heating of SS solutions leads to NMs of overall macroscopic dimensions; localized radiation using collimated electron beam is used to prepare metallized surface micropatterns. Depending on the composition of supraspherical precursors, nanoporous materials composed of up to three metals can be obtained. Strategies for controlling pore size and nanoscale surface roughness of these materials are discussed.}, author = {Klajn, Rafal and Gray, Timothy P. and Wesson, Paul J. and Myers, Benjamin D. and Dravid, Vinayak P. and Smoukov, Stoyan K. and Grzybowski, Bartosz A.}, issn = {1616-3028}, journal = {Advanced Functional Materials}, keywords = {Electrochemistry, Condensed Matter Physics, Biomaterials, Electronic, Optical and Magnetic Materials}, number = {18}, pages = {2763--2769}, publisher = {Wiley}, title = {{Bulk synthesis and surface patterning of nanoporous metals and alloys from supraspherical nanoparticle aggregates}}, doi = {10.1002/adfm.200800293}, volume = {18}, year = {2008}, }